![]() ![]() ![]() Insulating gloves and sleeves are considered insulation only with regard to the energized parts upon which work is performed. (1) The qualified person is insulated or guarded from energized electrical conductors or circuit parts operating at 50 volts or more. No qualified person shall approach or take any conductive object closer to exposed energized electrical conductors or circuit parts than the restricted approach boundary set forth in Table 130.4(E)(a) and Table 130.4(E)(b), unless one of the following conditions applies: Under no circumstance shall unqualified person(s) be permitted to cross the restricted approach boundary.ġ30.4(G) Restricted Approach Boundary. Where there is a need for an unqualified person(s) to cross the limited approach boundary, a qualified person shall advise the unqualified person(s) of the possible hazards and continuously escort the unqualified person(s) while inside the limited approach boundary. (3) Entering the Limited Approach Boundary. Where one or more unqualified persons are working at or close to the limited approach boundary, the alerting methods in 130.7(E) shall be applied to advise the unqualified person(s) of the electrical hazard and warn him or her to stay outside of the limited approach boundary. (2) Working at or Close to the Limited Approach Boundary. Unless permitted by 130.4(F)(3), no unqualified person shall be permitted to approach nearer than the limited approach boundary of energized conductors and circuit parts. Once there, click on the free access link to NFPA 70E. For the complete section, see the actual NFPA 70E text at NFPA.ORG. The shock protection boundaries and the arc flash boundary are completely different and independent of each other.īelow is a sample of NFPA 70E. It is critical to understand that in certain instances, the arc flash boundary might be a greater distance from the energized electrical conductors or circuit parts than the limited approach boundary. Table 130.4(E)(b) is used for the distances associated with DC system voltages.Table 130.4(E)(a) is used for the distances associated with AC system voltages.These boundaries are determined from using two separate tables: In Section 130.4(E) of NFPA 70E, there are two shock protection boundaries that apply to personnel approaching exposed energized electrical conductors or circuit parts: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |